![]() ![]() ![]() That's how you extract a basic key that stuck into or broke off into the lock. If it gets jammed up, give it a yank or two to see if it might come out or get it unloosened, then start over. The Spiral Key Extractor by HPC part number EZ-5 has metal bar spirals on it that help grip the key and also have the pattern set up that when to twist, the extractor will pull whatever its up against. The important part is to put pressure against the key with the spiral while you're twisting it. Get some angle until the broken key starts coming out. Once you have the grip, start twisting the extractor. Then, gently bend the extractor on the side to get some leverage on the key. It is built to include a cylinder lock with 2 keys. So, we're going to try to attack it on the bottom right groove by sticking the spiral extractor as far as you can. The key cabinet features solid steel construction, a durable powder finish, and capacity to hold 40 keys. But on the bottom right, it looks pretty open. Since this one is learning to the right when broken off, the groove is hard to see on the left. This Camlock has a Y11 keyway, then try to find the grooves of the key. ![]() What I got here is a typical situation, a camlock with a broken key and a little under the flush that can't be pulled out using needle nose, pliers, or tweezers. It is because the jammed key will require quite a bit of force to get it out. Typically, using a key extractor is ideal for when the keys have just broken off and not when a key has been jammed. Remove broken Keys from any lock using the finest tools available designed with the proper weight and balance and handling. The other typical lock that has a key broken off in it will be when a wrong key has been jammed into the lock and tried to be forced over, then breaks. A handle for a broken key extractor, the handle capable of holding a selectively removable 0.050-inch broken key extractor blade such that a tensile force of at least about 50 pounds is required to remove the blade from the handle using a SCOTT J Model Tensile Tester.And over time, as you turn it, it's just going to break off in it. Maybe there's a deep cut, the lock doesn't turn over very good making it sticky, or the lock is frozen or gummed up. Over time, the key has gotten worn right around the shoulder area.There are typically two reasons that a lock has a broken key in it. The second part is the press brass handle, which is great when you do need to get a little aggressive you can always clamp on a pair of vise-grips or something. The Spiral Key Extractor by HPC part number EZ-5 has metal bar spirals on it that help grip the key and also have the pattern set up that when to twist, the extractor will pull whatever it's up against. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |